Home > Power Supply > Power Supply Fuse Keeps Blowing

Power Supply Fuse Keeps Blowing

Contents

Resolution: Reference The 914 Installation instructions. Once AC versus DC and polarity (if relevant) are determined, start low on voltage to see at what point the device behaves normally. I guess I'm just not meant to have that much power in one room. If the fuse box for the house is tripping he has a deeper problem than what the computer is causing. http://linux4newbie.com/power-supply/how-to-test-power-supply.html

However, where it is used in some other application, the life of the adapter and the equipment may be much shorter than expected, possibly failing almost immediately. Either a supply works or it protects itself. I inherited a Sony Discman from a guy who thought he would save a few bucks and make an adapter cord to use it in his car. All wall warts are often called transformers.

Power Supply Fuse Keeps Blowing

Report • #1 T-R-A May 12, 2011 at 03:56:24 Technically, this should be in the Hardware forum. Make sure you don't rip into internal components! Even if the connectors are identical, it's a coin toss as to whether the center is positive or negative. You need to replace the power supply with a new one.

There are several basic types. But my PC is back in working order with all the new parts (including the HDD). A series diode would protect against reverse polarity. Computer Power Supply Trips Circuit Breaker Voltage rating should not be exceeded, though using a slightly lower voltage adapter will probably cause no harm though performance may suffer.

b_profaneSep 26, 2015, 10:25 PM westom said: Informative would be that second hard drive as an only connection to that new supply. Dude i have sold alot of computers in my time. awesomeguy 6.425.158 weergaven 5:10 How to Fix Xbox 360 Power Block/Brick Red Light Problem! - Duur: 3:17. https://www.repairfaq.org/sam/aapsfaq.htm What happens if other components of a PC drains more power than the PSU can supply?

You should be able to measure AC voltage at the secondary side of the transformer, between pairs of terminals. Psu Blew Up I have connected the original PSU to the original pc and then run these tests. I figured it would work because before I was doing the same thing with a DC wall plug that I had stripped the ends off of and it worked fine but Navigatie overslaan NLInloggenZoeken Laden...

Computer Power Supply Fuse Location

If the output is cycling, it could be a shorted diode or capacitor, or a bad controller.

All Rights ReservedAd Choices The information on Computing.Net is the opinions of its users. Power Supply Fuse Keeps Blowing I never saw so many little leads sticking up from any PCB since - that once were capacitors and top hat transistors. Power Supply Fuse Blown If it also has same symptoms, then a pattern exiss.

But that also is part of the second (larger) power supply and therefore remains off after an initial attempt to power on.Most failures are due to manufacturing defects. http://linux4newbie.com/power-supply/power-supply-switch-on-off.html Resolution: The following could cause the fuse to blow in the power supply with devices shipped prior to 8-24-2015 with solenoid driven when Chexit device is arming. Yahya Tawil Building Raspberry Pi Controllers Part 6: Displaying Messages on a LCD with a RPi Readers will learn how to wire a standard 16x2 LCD (liquid crystal display) to a Maximum output current is 1 A. Smps Fuse Blown

  • This repair may not be pretty, but it will work fine, is safe, and will last a long time if done carefully.
  • You just know more than the folks you are selling to.
  • I have read about building a control box with a halogen light and a variable resistor to control the amperage, but would it allow me to take some of the load
  • I am not using it for small knife etching, but for etching 5"x4" plates in a small tank.
  • Quick start-up followed by complete power off.
  • The best way would be to find the information without serious testing.
  • I never have.
  • Report • #21 phi11 May 15, 2011 at 00:16:45 Lol, sure have seen one of thoughs.
  • Disk drive, for example, has two voltages - 5 and 12.
  • solved Help me find the fuse of this power supply Power pack fuse blows when pc turned on Power Supply blew house fuse solved Power supply blowing solved psu blowing fuse

This will also reduce the output of your etching current. Determine the proper current rating of the fuse by dividing the transformer’s “VA” rating by 120 volts: in other words, calculate the full allowable primary winding current and size the fuse About AC Adapter Ratings The following mainly applies to AC adapters using transformers. navigate here As long as the input is always greater than your desired output voltage plus 2.5 V, the regulator will totally remove this ripple resulting in a constant DC output independent of

clone945945 12.953.223 weergaven 2:58 Evolution of Graphics on Xbox - Duur: 22:28. Computer Psu Repair Deze functie is momenteel niet beschikbaar. DlNKYDANA 618.220 weergaven 5:46 Testing an Xbox 360 with an ATX power supply - Duur: 3:57.

Transformers may draw high “surge” currents when initially connected to an AC source, and these transient currents will blow a fast-acting fuse.

Maybe it wasn't getting proper ventilation over 4 years and the dust killed it? westomSep 25, 2015, 4:10 PM b_profane said: So, back to the title of this thread: could something about the old system (which fried the old PSU) have also damaged this PSU? User questions FAQs Category List “ power supplies fuses ” RELATED FAQS Question Answer AC is fuse blowing on a PS914 when AC power is applied. Smps Fault Finding The obvious (original problem) would be hard or intermittent shorts or a seriously underrated supply (which you should have determined before your next P/S purchase).

If you are using actual fuses, you should probable upgrade to breakers. Some really expensive hard to obtain parts blew up. Why? his comment is here Use a larger or additional capacitor or a regulator in such a case.

That was another issue I had as well though. The design of the device may assume that this voltage is never exceeded and include no internal regulator. At least wall sockets are standardized - wall adapters are not. Laden...

UL (Underwriters Lab) approval means that the adapter has been tested to destruction and it is unlikely that a fire would result from any reasonable internal fault like a short circuit Since it has been about 5 years since I last bought these components, I felt it was time for an upgrade anyway. westomSep 25, 2015, 12:30 AM b_profane said: ... Without something approaching five volts.

Resolution: MPB840 = PS914power supply, MPB842 = PS914-2RS power supply. All that would be OK if these were for you only. Example 2: A cordless VAC battery charger adapter might produce 6 VAC. This may be the case when running equipment from batteries as well as from a wall adapter that outputs a DC voltage or the enhanced adapter described in the section: Converting

With the power switch in the 'on' position, testing across the AC plug should result in a resistance of 1 to 100 ohms depending on the size of the equipment: Small For example, was a paper clip test conducting while connected or disconnected from the motherboard? westomSep 23, 2015, 5:48 AM b_profane said: The last thing I want to do is plug it into the setup and see it get fried as well. LM317 is one example - Radio Shack should have it along with a schematic.

Compact AC Adapters These use switchmode power supply technology and can therefore be quite small and light weight. Anyway, this is a strange one, I guess. Thanks bros. The PSU fan was facing the bottom of the chassis, and that was sitting on carpet.

Check and see if you can get a replacement for that PSU, and run it on another system if possible to make sure it works. What size is the fuse in the PS873? All read 0.00, both before, during and after I turn on the power button.